Show Line? command

[daniel.bowen]

Hi everyone,

I have a Cisco 2610XM router with a PRI interface connected to an ISDN30. Could somebody tell me the command to see how many of the 30 lines are up at any one time?

Many thanks,

Daniel

[jolmo]

Hi Daniel

Try "sh isdn status"

HTH

[daniel.bowen]

Many thanks,

Where it says

Layer 3 Status:

30 Active Layer 3 Call(s)

does that mean that all 30 channels are up?

Daniel

[jolmo]

I think so.

You can also try "sh isdn active" to see active calls and "sh isdn service" to see every channel state.

HTH

[vcjones]

Assuming you have authentication requirements on incoming calls, the "show user" command will tell you who is logged in on each line.

Good luck and have fun!

Vincent C Jones

www.networkingunlimited.com