05-09-2002 02:24 AM - edited 03-01-2019 09:40 PM
Hi,
I have a 2Mbps point to point leased line between 2 places, I want to slice the bandwidth Half, like 1Mb for all the FTP traffic. remaining 1 Mb for Telnet traffic.
Can I do this using frame-relay? If so, Please guide me on this. I am going to connect these locations using Cisco3640 & Cisco 2620 routers. For configure Frame-relay between these two locations, Do i need IP-Plus software?
Thanks in Advance.
Ganesh.I
05-09-2002 04:28 AM
You can rate limit the traffic using the "rate-limit" command.
JPL
05-15-2002 04:02 AM
Hi,
The rate-limit feature is a nice one. You can slice traffic on protocol-type. You don't need Ip-plus for it. Native IP IOS software will do. Regards .....
05-16-2002 01:16 PM
Hi
Thanks for your information
Regards
Ganesh
05-17-2002 06:57 AM
Bestway to acheive bandwidth management is by using class maps & policy statements.
e.g.
class-map match-all default
match any
class-map match-all ftp
match access group 101
class-map match-all telnet
match access group 102
policy-map XYZ
class ftp
bandwidth 1000
class Telnet
bandwidth 1000
101 & 102 are your extended ip access lists allowing ftp & telnet traffic respectively.
and then apply this policy to the interface like this
interface Serial1/0
service-policy output xyz
05-18-2002 07:22 AM
Hi sachin,
really nice. Thank you very much
Ganesh
05-20-2002 07:39 AM
This policy above ... just to make it clear in my mind ... will it limit ftp and telnet traffic to 1mb and allow unlimited bw to all other types of traffic on s1/0.
Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide