Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi - IPT newbieWe have CCM 4.0 and we are looking to integrate this into our PBX infrastructure. I am looking to use QSIG signalling between the MD110 and a 2651XM with the aim-30-voice and a VIC-1MFT-E1 in it. When I come to add the gateway on the C...
HiI have a pix with 6.3(3)I am doing a site to site vpn with a router.The clients on the DMZ need to communicate with the far end site cleints.I have configured this for nataccess-list no_natVPN permit gre 172.16.194.0 255.255.255.0 172.16.193.0 255....
Hi, We are starting to roll out site-to-site vpns. At the remote site, we will have an 828 router and at the Hub will be a Checkpoint firewall. An ipsec tunnel will run between the two. At the remote site is also an ISDN router which will be used for...
HiI have a 7505 with two CIP cards in and a 4port token ring card (amongst other things). The 7505 will have 2 escon connections to the mainframe. I wish to implement CLAW load balancing across the 2 CIP cards, although the clients will use one IP ad...
Hi - I still have a problem with this. We have a site to site vpn with gre which up until today had tested ok. The VPN is up ok, the gre tunnel is up ok and we can ping between sites. For a 32byte ping, response between sites is 99% but as you increa...
Thanks for reply - not sure how the soltuion you mentioned would work. Could you explain a little further or send a sample config The Checkpoint connects to remote sites using IPSec over the web. We have a leased line to the internet provided by UUn...
Hi OscarThanks for your answer ..... The servers are on the internal LAN and I cant shift them to the dmz, so I will allow access from outside to inside with conduits and also configure NATTHanks for your reply
