Slot1 as default Supervisor on Cat4507R

[s.srivas]

At the moment Slot2 redundant supervisor becomes active all the time.

I want to make Slot1 Supervisoer as active all the time, except when there are problems with this slot,

Please advice if any special command is available to make this happen.

[aashish.c]

Hi,

A switchover between 2 SUPs will occur when one or more of the following events take place:

•The active supervisor engine fails or is removed.

•A user forces a switchover.

•A user reloads the active supervisor engine.

•A core dump occurs.

To force a switch over you can also use this command :

redundancy force-switchover

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat4000/12_2_20/config/rpr.htm

kindly update for further reference

regards

aashish C

[ankurbhasin]

Hi,

It does not matter that sup is in slot 1 or slot 2. What matters is which sup came up first or which is inseretd first. Could be in your case sup in slot 2 is been inserted first or would have come first and is the reason is active. Force the switchover and sup in slot 1 will be active.

Hope it helps.

Ankur