Hi community,
I have stumbled upon an interesting problem. The Standby RP, switch 1 currently, is suffering from high memory utilization which could only be discovered by Cisco DNAC and this command:
show platform software status control-processor.
The output tells me the memory utilization of slot1-RP0 is 83%, while slot2-RP0 stays as low as 26%.
It is quite unfortunate as any other show memory - like commands output utilization of around 23% - my guess is that it is because they are executed by the active RP, which's utilization is around that number.
The hardware used is Catalyst 9500 running IOS-XE 17.06.04
Does anyone have any experience or advice on how to deal with this?
