Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community,
I have stumbled upon an interesting problem. The Standby RP, switch 1 currently, is suffering from high memory utilization which could only be discovered by Cisco DNAC and this command:
show platform software status control-processor.
...
Hi Leo,
How can you tell so surely that slot 1 is not the standby RP?
Mac persistency wait time: IndefiniteH/W CurrentSwitch# Role Mac Address Priority Version State-------------------------------------------------------------------------------------...
Hi Flavio,
Thank you for your answer, however I do not think that this problem is caused naturally by heavy load in the system, since the active RP, which produces most of it, keeps its memory utilization low.
There is an access-list that is logging...
The Catalyst 9200L platform is not included in the known affected hardware list. I have reported this to TAC and am currently working on solution. I am going to post the result of our investigation once done. This bug discussion post is rather inform...
