All,
I tried to upgrade Cisco 6500 from Sup-2 to Sup-6 running IOS cat4500e-entservicesk9-mz.122-40.SG.bin.
After upgrade everything came back up normal , no problem with hardaware.
Except with private VLAN community.
After this upgrade I can not configure "Private VLAN comunity" on this switch.
AUNN00RS_XXXXX(config-vlan)#private-vlan community
% Invalid input detected at '^' marker.
AUNN00RS_MGMT1(config-vlan)#private-vlan ?
association Configure association between private VLANs
isolated Configure the VLAN as an isolated private VLAN
primary Configure the VLAN as a primary private VLAN
It works absolutely fine with Sup-2 running same IOS.
AUAN00RS_XXX(config-vlan)#private-vlan ?
association Configure association between private VLANs
community Configure the VLAN as a community private VLAN
isolated Configure the VLAN as an isolated private VLAN
primary Configure the VLAN as a primary private VLAN
Regards
Sachin