Does anybody know of an OID to measure the inlinepower of a card (I specifically want to get the readout from the below marked in bold):#sh powe Load for five secs: 2%/5%; one minute: 2%; five minutes: 2%Time source is NTP, 07:14:05.157 UTC Fr...
We have this E1 interface on a Cisco 3660 v12.2(7a)interface ATM2/0 no ip address ip route-cache flow atm vc-per-vp 256 no atm ilmi-keepalive scrambling-payload impedance 120-ohm!interface ATM2/0.1 point-to-point mtu 1500 bandwidth 512 ip address x.x...
Thanks for the pointer.Found the ones I'm after now SNMPv2-SMI::mib-2.105.1.3.1.1.4.1 = Gauge32: 113SNMPv2-SMI::mib-2.105.1.3.1.1.4.3 = Gauge32: 144SNMPv2-SMI::mib-2.105.1.3.1.1.4.8 = Gauge32: 125
Well, whether or not it send access-accept or access-reject is not the problem. The problem is a communication error because it can't reach the switch. We both have the same problem of the port being unreachable. In lh consultings case it was also an...
Sorry to bump such an old post but I'm having exactly the same issueon my 6500.Here's the TCP dump:14:59:28.545965 IP 192.168.254.2.21645 > MGMT4: RADIUS, Access Request (1), id: 0x4d length: 9014:59:28.548010 IP MGMT4 > 192.168.254.2.21645: RADIUS, ...
No worries mate. Gald to try and help......but my idea above still stands. You can create a DMZ on your router...do you have another interface? Anyway you put the PC in question in this DMZ and allow all IP traffic (cos its not really a DMZ, just ano...
Well, that's why it's not working. It should be interface vlan 50. Try it. It will work. If you want your router to talk to the switch in this VLAN (VLAN 50), in which you have configured the same IP address range, you need to create the VLAN 50 inte...