cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
264
Views
0
Helpful
1
Replies

TESTING LATENCY - DSL AND LS1010

scarlet.kennedy
Level 1
Level 1

What would be the best method to test latency through an ATM network with DSL? Specifically, the core is an LS1010 with 6130 and 6160 DSLAMS at remote offices. We use the 4-port FLEXI (w/ NI-1 and NI-2) and 8-port DMT (NI-2 only). The boxes connected to the LS1010 for access are a 7206 Router and the other an AAC-3 access concentrator.

The tests that I have done show differences between the 8-port card vs. the 4-port. The 8-port has a longer latency on a consistent basis. Or is this an NI-2 issue because actual traffic takes priority?

Any help is greatly appreciated.

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Review Cisco Networking for a $25 gift card