06-08-2020 04:30 AM
Hi there all,
Currently exploring our new ISR 4k router.
ISR Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.9.5
We have installed a UCS-E160S-M3/K9 - server. The purpose is to test the ability of this thing in our network. Dream goal is installing ubuntu with docker and deploy ip sla measurement. So far so good :-)
However:
I followed the Getting Started Guide of Cisco.
https://cdn.cnetcontent.com/8f/a8/8fa82c05-dcfc-4d31-a3b9-ee33a9c93d41.pdf
I verified the hardware, enabled the license and I started to give it an IP management address. I understood that it should enable the webinterface.
Then during the 'cli' configuration, I wasn't able to type cli command 'imc ip address <cimc-ip-address> <subnet-mask> default-gateway <cimc-gateway-ip-address>
I would guess that it has something to do with the firmware ?...
Any idea?
Thank you
Bart
Solved! Go to Solution.
06-08-2020 06:31 AM
Solved It myseld:
solution = RTFM
https://www.davideaves.com/2016/02/cisco-4000-series-isr-base-ucs-e-configuration/
and used the correct card slot.
I used same experience as with an etherswitch module. Then also apply 'console' to access the webinterface:
(config)#ucse subslot 2/0
(config-ucse)#imc ip address **** /**** default-gateway *****
(config-ucse)#imc access-port shared-lom console
good luck. hope this saved you a lot of time!
06-08-2020 06:31 AM
Solved It myseld:
solution = RTFM
https://www.davideaves.com/2016/02/cisco-4000-series-isr-base-ucs-e-configuration/
and used the correct card slot.
I used same experience as with an etherswitch module. Then also apply 'console' to access the webinterface:
(config)#ucse subslot 2/0
(config-ucse)#imc ip address **** /**** default-gateway *****
(config-ucse)#imc access-port shared-lom console
good luck. hope this saved you a lot of time!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide