04-10-2004 08:05 AM - edited 03-02-2019 02:55 PM
I have been using my catalyst 2950 without configuring it. Recently, I had a routing problem which I posted on my previous message and I decided to configure vlans on my switch but when I logged on to the console it displays unrecognised character or another language that I can't understand. Please any idea on how I can bring the switch back to display English Language? Thanks
~Kaycee
04-10-2004 08:09 AM
Our switches/routers only have English characters. What baud rate do you have? Try consoling in with 9600
04-10-2004 10:11 AM
The settings in the Hyper Terminal need to be set correctly; otherwise, "strange-looking" or garbage characters may show up on the screen. When setting up the connection, use the following settings:
Bits per sec : 9600
Data bits : 8
Parity : none
Stop bits : 1
Flow control : none
I have also had these problems with pin-out problems on cables and the serial connector attached to the PC.
John
04-11-2004 09:08 AM
I have done all this before, setting the baudrate etc and it's still bringing out the garbage.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide