Upgrading memory on LC-4oc3/PoS-MM

[johan.a]

We need to upgrade the memory on these cards from 64MB to 128MB but I can't find the productnumber for it. I found MEM-LC-PKT-128= but I am very uncertain that this is the right one, seems to cheap for this LC.

Brgds, Johan

[Harold Ritter]

You are probably looking at upgrading the processor memory since the default packet memory on the E0 LC is 128MB. The 128MB processor memory product number is: MEM-GRP/LC-128

If you want to display the current processor and packet memory on the LC, do a "sh diag .

Hope this helps,

[Harold Ritter]

After verification, it seems like the LC with the product number LC-4OC3/POS-MM has a default route memory and packet memory of 128MB. Could you please include a "show diag" for your line card to see what is the current route and packet memory.

Here's a show diag taken from one of my routers.

GSR-2_P2>sh diag 3

SLOT 3 (RP/LC 3 ): 4 Port Packet Over SONET OC-3c/STM-1 Multi Mode

MAIN: type 33, 800-2396-02 rev P0

Deviation: 0

HW config: 0x01 SW key: FF-FF-FF

PCA: 73-2147-07 rev B0 ver 4

Design Release 1.1 S/N CAB0539KLSV

MBUS: MBUS Agent (1) 73-2146-07 rev B0 dev 0

HW version 1.2 S/N CAT010101WD

Test hist: 0xFF RMA#: FF-FF-FF RMA hist: 0xFF

DIAG: Test count: 0x00000000 Test results: 0x00000000

FRU: Linecard/Module: LC-4OC3/POS-MM=

Route Memory: MEM-GRP/LC-128=

Packet Memory: MEM-LC-PKT-128=

L3 Engine: 0 - OC12 (622 Mbps)

MBUS Agent Software version 1.85 (RAM) (ROM version is 2.32)

ROM Monitor version 16.6

Fabric Downloader version used 24.5 (ROM version is 24.5)

Primary clock is CSC 1

Board is analyzed

Board State is Line Card Enabled (IOS RUN )

Insertion time: 00:00:15 (4w2d ago)

DRAM size: 134217728 bytes

GSR-2_P2>

Thanks,