username command on 3550

[frejac]

I'd be glad if someone here could point me to a document describing the 16 (0-15) privilege levels for the username command on a 3550.

Cant find them in the command reference or the configuration guide.

Thanks!

[frejac]

I'd like to use it to give some ppl rights to check interface status. It's important that they cant affect switch function or change any parameters.

[dfelter]

See the IOS 12.2 Security Configuration Guide and Command Reference in the URLs below:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fsecur_c/fothersf/scfpass.htm

and

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fsecur_r/fothercr/srfpass.htm

[frejac]

Okies. Thanks.

Let's see if I have understood this right, There are NO accesslevels that are per default accociated with any commands, except from level 0 and 15?

So I need to use the "privilege" command to give the user access to the different commands that I choose. and no matter how I configure, any access level other than 15 cant do a "conf t"?

[frejac]

Hmmm guess Im wrong. I did a "en 1" to enter level 1 without having any "privilege" commands set. I have made no configuration at all regarding this, but yet I could all "show"-commands. Not enter "conf t" tho.

What's the default levels?

[frejac]

Think I got it now. Level 1-14 are the same, and level 1 is default what you get into when you connect to the switch..