VLAN Tagging Setup.

[daileydd]

I have a network with 3550 switches and a 2620 router. I have computers and IP phones using a single drop to the desktops. I've programed the switch ports as trunk ports allowing traffice from both VLAN1 AND VLAN2. The computer are plugged into the phones. Everything is working great. My question.

I'm trying to get my computer to talk on both vlans. I want to be able to manage my server and the new IP PBX phone system. I've assigned my nic card with two static addreses, one for each network. The port my pc is plugged into is trunked. Any help is appreciated.

Thank you

[Prashanth Krishnappa]

Are you looking to route between VLAN1 and 2? You could configure your 3550 to do it. The following page should help

http://www.cisco.com/warp/public/473/189.html

[daileydd]

Thank you very much, I think this will help me.