10-27-2015 06:01 AM - edited 03-03-2019 08:01 AM
Community,
Just opened a WAVE 7541 and placed a config on it. I was all set to deploy it when I noticed the System Fault LED on.
I've checked out the show alarms and show alarms history (after a fresh reboot), and all is good (no alarms). Power supplies are good, memory is correct. I'm stumped. Anyone know why the LED won't turn off?
I have a TAC case open on this and will post the solution if we find one.
Thanks,
10-27-2015 07:16 AM
Community, Just opened a WAVE 7541 and placed a config on it. I was all set to deploy it when I noticed the System Fault LED on. I've checked out the show alarms and show alarms history (after a fresh reboot), and all is good (no alarms). Power supplies are good, memory is correct. I'm stumped. Anyone know why the LED won't turn off? I have a TAC case open on this and will post the solution if we find one. Thanks,
Hi Jacob,
If system fault LED is on , system has discovered some fault. Check out the below link from cisco for more details
Troubleshooting system Hardware
Hope it Helps.
-GI
10-27-2015 08:21 AM
GI,
Thanks for the share! I've been through that document at least twice.. no luck. Everything on the system checks out clean, no alarms in a show alarm or show alarm history. A peer of mine mentioned he'd seen this before, and there was a hidden command needed to clear the LED??
Waiting on TAC to figure it out.
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide