WCCP command not available. Image C3560-ADVIPSERVICESK

[garry_myers]

Hi community - NooB here.

Ive got a WS-C3560G-24TS set aside for WCCP running 12.2(25), Image C3560-ADVIPSERVICESK.  As far as I can see WCCP should be available, but the WCCP commands are not available.

result of 'ip wccp' results in % Unrecognized command.

'sh ip in' results in the following being shown:

WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled

I can only assume Im missing something to get WCCP activated on the unit - any help appreciated!  

Oh, and yes, Ive been through the documentation. :)

Thanks.

[Philip D'Ath]

This URL says how to set it up on a 3560.

http://www.cisco.com/c/en/us/support/docs/security/web-security-appliance/118006-configure-wccp-00.html

How you enabled an sdm template that supports wccp?  For example, execute the below and reboot:

sdm prefer routing

[garry_myers]

Hi Philip, thanks for hte quick response.

Ive been through that doc already, and set sdm preference to routing:

AUSY-WCCP01#sh sdm prefer
The current template is "desktop routing" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.

number of unicast mac addresses: 3K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 11K
number of directly-connected IPv4 hosts: 3K
number of indirect IPv4 routes: 8K
number of IPv4 policy based routing aces: 512
number of IPv4/MAC qos aces: 512
number of IPv4/MAC security aces: 1K

I note though that the routing template Im using is 'desktop routing'.  Are there any other variations of the routing template that I should be using?

Cheers mate.

[Philip D'Ath]

Hmm, I'm not sure.  Perhaps try a slightly later software version - even though it says it is supported in 12.2(25).

[garry_myers]

Hi guys, thanks for your assistance.

updated to 12.2(55) ipservices and its working fine. 

Thanks again,

Garry.

[Jon Marshall]

That is the correct template.

However I think the docs are misleading.

I just checked the release notes and the first mention of WCCP being supported is with 12.2(37)SE so I suspect that is the problem.

http://www.cisco.com/c/en/us/support/switches/catalyst-3560-series-switches/products-release-notes-list.html

Jon

[garry_myers]

THanks Jon, appreciate the reply.

Im updating to 12.2(55)SE10 later today and will confirm.

Cheers,
Garry.