"Wet T1 features helps the WIC to work properly even when the WIC gets wet" --- LOL just kidding...please read below:
The v2 version of the WIC supports something termed as Wetting current. This current is usually provided by the CO to prevent corrosion of electric contacts in the card. This is a feature which can be disabled or enabled by using a jumper in the WIC. By default its disabled on the WIC. You should see a jumper connecting pins 2 and 3 on J2 connector. This disables the feature.Remove this jumper and connect it to pins 1 and 2 and it will become enabled.
Hope that helps!
Sankar Nair
UC Solutions Architect
Pacific Northwest | CDW
CCIE Collaboration #17135 Emeritus
