08-05-2003 10:36 PM - edited 03-02-2019 09:22 AM
I issue command "show inter" , and my c2950 give me this :
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 176000 bits/sec, 177 packets/sec
925560 packets input, 65196665 bytes, 0 no buffer
And another one is :
5 minute input rate 177000 bits/sec, 178 packets/sec
5 minute ouxtput rate 0 bits/sec, 0 packets/sec
14717408 packets input, 313382703 bytes, 0 no buffer
This is the output of "show ver"
c2950 uptime is 19 hours, 43 minutes
System returned to ROM by power-on
System image file is "flash:/c2950-i6q4l2-mz.121-13.EA1.bin"
cisco WS-C2950-24 (RC32300) processor (revision J0) with 20839K bytes of memory.
Processor board ID FOC0720X2C6
Last reset from system-reset
Running Standard Image
24 FastEthernet/IEEE 802.3 interface(s)
08-06-2003 12:10 AM
Hi,
it seems like a bug to me.
I can see
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute ouxtput rate 0 bits/sec, 0 packets/sec
on the switch side
and
5 minute input rate 1000 bits/sec, 4 packets/sec
5 minute output rate 9000 bits/sec, 3 packets/sec
on the other side of the same line where a router is connected.
But no bug found using Bug Navigation Tool.
Regards,
Milan
08-06-2003 01:18 AM
Is the port with output rate 0 in a BLOCKING state?
"show spanningtree interface
08-06-2003 05:24 PM
No , the ports are in forwarding stat , and I have try the image : c2950-i6q4l2-mz.121-11.EA1.bin , but nothing changed .
08-06-2003 03:16 AM
what is this port conencted to ? the routing metrics may be influencing the way the input and output traffic is flowing
08-06-2003 04:38 AM
No,
the topology is:
switch---router---WAN
and the sh int output is from both sides of the line between the router and the switch.
Port is up and data is transported through it.
I've notice following:
Last input 00:00:59, output 00:00:01, output hang
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 1000 bits/sec, 1 packets/sec
But I was sending ping -t -l 1000 (i.e. 1000 Bytes each 2 seconds) through the line that time.
According Last input 00:00:59 it seems like a bug.
Regards,
Milan
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide