Dear Professional
environment is Cisco 2650 router, using wic-1adsl,
and line is Korea KT ADSL
What's the matter ?
following output is debug atm ... command.
OK LED : ON
CD LED : OFF
*Mar 1 09:26:14: DSL: Send ADSL_OPEN command.
*Mar 1 09:26:14: DSL(ATM0/0: Using subfunction 0x15
*Mar 1 09:26:14: DSL(ATM0/0): Sent command 0x3
*Mar 1 09:26:16: DSL(ATM0/0): 1: Modem state = 0x8
*Mar 1 09:26:19: DSL(ATM0/0): 2: Modem state = 0x8
*Mar 1 09:26:21: DSL(ATM0/0): 3: Modem state = 0x8
*Mar 1 09:26:23: DSL: Received response: 0x22
*Mar 1 09:26:23: DSL: Open failed: Protocol error received -- retrying
*Mar 1 09:26:23: DSL: Send ADSL_OPEN command.
*Mar 1 09:26:23: DSL(ATM0/0: Using subfunction 0x15
*Mar 1 09:26:23: DSL(ATM0/0): Sent command 0x3
*Mar 1 09:26:25: DSL(ATM0/0): 1: Modem state = 0x8
*Mar 1 09:26:26: DSL: Received response: 0x22
*Mar 1 09:26:26: DSL: Open failed: Error in early non-CRC message or in first C
RC-covered message -- retrying
*Mar 1 09:26:26: DSL: Send ADSL_OPEN command.
*Mar 1 09:26:26: DSL(ATM0/0: Using subfunction 0x15
*Mar 1 09:26:26: DSL(ATM0/0): Sent command 0x3
.
.
.