12-21-2004 07:16 PM - edited 03-02-2019 08:43 PM
HI There,
Anyone can assist me on WIC-2FXS card,
The problem is when I shut the voice port and the FXS is down.
IS the any command which can active the WIC-FXS card beside Shut and No Shut
Thanks
Sim
Foreign Exchange Station 1/1/0 Slot is 1, Sub-unit is 1, Port is 0
Type of VoicePort is FXS
Operation State is DOWN
Administrative State is UP
The Last Interface Down Failure Cause is Administrative Shutdown
Description is not set
Noise Regeneration is enabled
Router#sh dsp
DSPFARM Configuration Information:
Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN
Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 0 (Avail: 0)
Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600
Connection check interval 600 Codec G729 VAD: ENABLED
12-21-2004 08:27 PM
Have you plugged a phone to FXS port yet ?? Do you get dialtone when you go off hook ? "no shut" should bring it back to normal..
12-27-2004 12:47 AM
Hi There,
Thanks for your reply..
Yes I have connected phone to both FXS port.
Initially one voice port No Dial tone.
so I shut the voice port....then I No Shut the voice port.
After that both VOICE port no dial tone.
So I have to reset the router..then both voice are back to normal.
Is the any specific command to shut the voice port beside NO SHUT
Thanks
Regards
David
12-27-2004 08:01 AM
Have you created a POTS port yet. Normally you will do nothing to the voice-port itself but configure the POTS as such.
PBX(config)#dial-peer voice 1 pots
PBX(config-dial-peer)#destination-pattern 9001
PBX(config-dial-peer)#port 1/0/0
You configure the dial-peer, add the number to it via the destination-pattern and then tie the physical voice port to the dial-peer. You can then configure another POTS line as such by creating dial-peer voice 2 and then add the other voice port to it with a different phone number. You at that point should have dial-tone on each of the phones and should be able to dial each other.
Hope this helps,
Jason Smith
12-27-2004 10:51 PM
Hi Jason Smith,
Good Day,
Thanks for your reply.
Yes, I did configured dial peer voice 1 port too
Below is my config.
voice-port 1/0/0
cptone MY
!
voice-port 1/0/1
cptone MY
!
dial-peer voice 1 pots
destination-pattern 80541
port 1/0/0
no register e164
!
dial-peer voice 2 pots
destination-pattern 80542
port 1/0/1
no register e164
!
dial-peer voice 100 voip
destination-pattern .....
session target ras
dtmf-relay cisco-rtp
ip qos dscp cs5 media
no vad
!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide