WIC-FXS down after shutdown the voice port

[seheng]

HI There,

Anyone can assist me on WIC-2FXS card,

The problem is when I shut the voice port and the FXS is down.

IS the any command which can active the WIC-FXS card beside Shut and No Shut

Thanks

Sim

Foreign Exchange Station 1/1/0 Slot is 1, Sub-unit is 1, Port is 0

Type of VoicePort is FXS

Operation State is DOWN

Administrative State is UP

The Last Interface Down Failure Cause is Administrative Shutdown

Description is not set

Noise Regeneration is enabled

Router#sh dsp

DSPFARM Configuration Information:

Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN

Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 0 (Avail: 0)

Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600

Connection check interval 600 Codec G729 VAD: ENABLED

[thisisshanky]

Have you plugged a phone to FXS port yet ?? Do you get dialtone when you go off hook ? "no shut" should bring it back to normal..

[seheng]

Hi There,

Thanks for your reply..

Yes I have connected phone to both FXS port.

Initially one voice port No Dial tone.

so I shut the voice port....then I No Shut the voice port.

After that both VOICE port no dial tone.

So I have to reset the router..then both voice are back to normal.

Is the any specific command to shut the voice port beside NO SHUT

Thanks

Regards

David

[smif101]

Have you created a POTS port yet. Normally you will do nothing to the voice-port itself but configure the POTS as such.

PBX(config)#dial-peer voice 1 pots

PBX(config-dial-peer)#destination-pattern 9001

PBX(config-dial-peer)#port 1/0/0

You configure the dial-peer, add the number to it via the destination-pattern and then tie the physical voice port to the dial-peer. You can then configure another POTS line as such by creating dial-peer voice 2 and then add the other voice port to it with a different phone number. You at that point should have dial-tone on each of the phones and should be able to dial each other.

Hope this helps,

Jason Smith

http://www.smif101.com

[seheng]

Hi Jason Smith,

Good Day,

Thanks for your reply.

Yes, I did configured dial peer voice 1 port too

Below is my config.

voice-port 1/0/0

cptone MY

!

voice-port 1/0/1

cptone MY

!

dial-peer voice 1 pots

destination-pattern 80541

port 1/0/0

no register e164

!

dial-peer voice 2 pots

destination-pattern 80542

port 1/0/1

no register e164

!

dial-peer voice 100 voip

destination-pattern .....

session target ras

dtmf-relay cisco-rtp

ip qos dscp cs5 media

no vad

!