7505 RSP error message - worry on not?

[s.souroutis]

Hi all,

Lately I had an RSP2 module on my 7505 router replaced because of failure. My functionality problems were solved, but I get an error message every time I reload/power cycle the router.

%RSP-3-ERROR: dbus read at 3E841002

-Traceback= 6022A528 6022CA90 6022D050 60230330 601D45A4 601D4658 60148908

-Traceback= 601FDBD8 601FF6FC 601BC29C 601D9610

00:02:09: %SYS-3-LOGGER_FLUSHING: System pausing to ensure console debugging out

put.

%SYS-6-BOOT_MESSAGES: Messages above this line are from the boot loader.

Can somebody explain to me what this is?

the router seems to be fully funcional but should I worry about that?

Thanks in advance

[Prashanth Krishnappa]

What IOS version are you running?

Take a look at the following bug

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCdt00655

[s.souroutis]

Hi Prashanth

I looked at the bug and it was very familiar :)

The IOS I use is rsp-jsv-mz.123-10.bin. I changed before replacing my previous RSP module just in case of a bug.

The bug mensioned about upgrading also the boot image to a version including the fix.

My bootflash image is rsp-boot-mz.120-8.S

I think here I have a problem with the size. My bootflash size is 7602176. A latest image (12.3.10) would require a min Flash of 32MB

Is bootflash upgradable???

Thank you for your help

[s.souroutis]

OK. I found out where bootflash SIMM locates on the board. All I need is a larger-sized one and I'll try a newer version image.

Would you suggest anyone??

12.0(16), 12.2(0.10), 12.1(6.6), 12.2(0.10)T, 12.0(16.1), 12.1(7.1), 12.1(6.6)AA, 12.0(15.6)S01, 12.0(16.3)S, 12.0(16.3)ST, 12.2(0.18)S, 12.1(7.5)E, 12.0(17.6)W05(21.16), 12.1(08a)E, 12.1(7.5)EC, 12.2(2)B, 12.2(15)ZN, 12.0(27)SV

[Prashanth Krishnappa · Accepted solution]

Try the latest boot image as well(rsp-boot-mz.123-10.bin)