bridge-group

[mehrdad]

Hi

anybody confirm the following scenario ?

ethernet<-xDSL modem->ppp ----leased line ---- ppp<-XDSL modem->v.35<-router->ethernet

- The serial interface in router and the ethernet on router are member of same bridge group

- Bridge between two end points is needed

Regards,

M.Arshad rad

[a.awan]

This should work but keep in mind that on Cisco routers IP is routed by default so if you want to bridge IP you either have to turn ip routing off or use a mechanism like Integrated Routing and Bridging (IRB).