How to configure VLAN and port-security with float mac-address?

[mmadruga]

Is it possible to have this solution -

port-security with 1 static mac-address configured for each port BUT with a possibility that a specific group of mac-address( notebooks) could be connected on any port?

Thanks in advance,

Marcelle.

[Georg Pauwen]

Hello,

why don't you just configure all the notebook MAC addresses on each port, and add the one specific to each port ?

switchport port-security mac-address mac-address [vlan vlan-id]

So basically, each port will be configured so that all notebooks have access, and each port will have a different MAC address in addition to the group of notebook MAC addresses.

Would that be a feasible solution for you ?

Regards,

GP

[mmadruga]

GP, thanks for your help.

Good solution for a small scenery. Probably we'd need to analyze if it would be feasible for a topology with 25 switches. Probably there will be a maximum number of MAC that can be add for each port. We´d need to check it too.

Thanks again.

Marcelle.