Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Sirs,There is no snmp-server enable traps configured. The show snmp confirms that snmp global trap and snmp logging are disabled. The only command configured is snmp-server community XX . Why when I run a scan tool it shows that port udp 162 (snmptr...
Is there any command that i can use on a voip gateway 3640 to see the voice packet size exiting the interface? How much of the bandwidth a voice packet uses?Thanks in advance.
Is there any way to configure SNMP in a Catalyst 3550 to restrict MIBs (OID) that are sent to the SNMP Manager(Server)?The server is suposed to receiver only some informations from the switch(interface up/down, CPU, memory) and I'd like to make sure ...
Is it possible to have this solution -port-security with 1 static mac-address configured for each port BUT with a possibility that a specific group of mac-address( notebooks) could be connected on any port?Thanks in advance,Marcelle.
We'd like to configure DHCP snooping on a local network using switches Cisco 2950 and switches 3750.The DHCP server and clients are on the same subnet so we do not need to configure DHCP relay and the DHCP server does not support option-82 so we won...
Thank you all for the attention and replies.It really seems that the snmp agent enable/open this port unnecessarily. I wanted to disable/close the port but it seems i only have the option to filter the access.
In fact, i'd like to understand why this port is open if i did not enable traps. I understood that there are only two options to enable traps:using the commands snmp-server enable traps or snmp-server host X.In this case, neither of the commands are ...
Thanks for you answer.The link you mentioned was good. I found the following link which added more information: http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094489.shtmlThanks again,
GP, thanks for your help.Good solution for a small scenery. Probably we'd need to analyze if it would be feasible for a topology with 25 switches. Probably there will be a maximum number of MAC that can be add for each port. We´d need to check it too...
Hi! I just want to make a comment. I had a similar problem and when I saw your question and the answers you got, I remembered the case I opened(Case E284406)We connected a Catalyst 2950 to Nokia Firewall 330 (we had a switch 3COM before) and the resu...
