02-17-2003 12:05 AM - edited 03-02-2019 05:08 AM
I have a 3640 running IP over Ethernet & BRI.
The load (show proc) runs anywhere from 4 - 14 %.
When I enable IP accounting the load jumps to 100%
The router is so busy I cannot do any analysis as I have to remove IP accounting to allow my userts to work.
I have 4 ethernet ports 3 internal 1 extrnal to the Internet, I leave ip accounting
switched on the internal ports No Problem.
As soon as I enable the port to the Internet the load jumps to 100 %.
Any ideas would be welcome
02-17-2003 12:11 AM
what is the size of the pipe & what is the load when you enable ip accounting ? did you try to enable it just on the wan link ?
What is the process that is eating up the cycles on your CPU ?
02-17-2003 01:02 PM
Hi the pipe is a 10 mb 1/2 duplex.
The load before enabling ip accounting on the router is between 3 - 15 %.
As soon as ip accounting is enabled the load jumps to 100 %.
(even if it is only 3% when we start)
Yes I have tried just the WAN connection with exactly the same results.
As for the process that is running.....I am not sure. I will have to test this again during the night when it won't effect my users to much.
I assume I should run "show proc" & look for the culprit??
02-24-2003 05:18 PM
OK; So I did some testing over the weekend.
I could NOT find any process consuming all the cycles.
However when I "Shutdown" my BRI ports the problem disapeared.
I am running 12.0(7T) on this router
Basic Rate ISDN software, Version 1.1.
6 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
8 ISDN Basic Rate interface(s)
Integrated NT1's for 8 ISDN Basic Rate interfaces
DRAM configuration is 64 bits wide with parity disabled.
125K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
.
Any other Ideas ????
02-24-2003 08:31 PM
IP accounting is a cpu intensive as ios has to calculate umber of bytes and packets switched through the Cisco IOS software on a source and destination IP address basis.
We need to see output of "sh proc cpu" to see which process is spiking the cpu. Cpu may be spiking because of interrupts. Here is the url for troubleshooting that.
02-25-2003 09:53 AM
Also, doesnt IP Accounting turn off CEF?
I may be wrong here, but Im pretty sure it does, so youll be back to process switching everything.
You may be better of looking at Netflow, as that does work with CEF.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide