Cisco Community
English
Register
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

142
Views
0
Helpful
1
Replies
Highlighted
sisko6101
sisko6101 Beginner
Beginner
‎01-14-2020 01:55 PM
‎01-14-2020 01:55 PM

Packet tracer sample labs

Where are the solutions to the sample labs. I believe in older versions of PT the solutions were included in the instructions which was a separate window. The version I am using 7.3.0 does not have this, only instructions next to the topology.

0 Helpful
Reply
1 REPLY 1
kapydan88
kapydan88 Beginner
Beginner
‎01-18-2020 01:57 AM
‎01-18-2020 01:57 AM

Re: Packet tracer sample labs

Hi.

 

Where did you find this labs? Usually the answers are located on the same site as the labs/tasks. Try looking there.

0 Helpful
Reply
Latest Contents
PRTG monitoring - Sensor Syslog receiver not receiving all ...
Created by Barry Landon on 01-24-2020 05:20 AM
2
0
2
0
PRTG system in place running other sensors on the same host, which are working.  Ive added syslog receiver sensor and receiving PRTG data from switch that increases drops, errors and warning stats that disappear after a few minutes.  Within mess... view more
Setting up a GRE tunnel (IP-NAT, GRE AND IPSEC)
Created by Bananaman on 01-23-2020 02:00 PM
0
0
0
0
Hi, here is an example how to configure IP-NAT, GRE, IPSEC. I've seen plenty of questions and this might be a good solution! (Mostly the use of commands that might remind u) IP NAT======================================================================... view more
OSPF "INIT/DROTHER" error
Created by MrMaregaTech on 01-22-2020 04:45 AM
5
0
5
0
Hi everyone.I have a problem in my Network.So i have 3 routers and a firewall in my topology. I have configured OSPF and all routers works expect R3 (see in the image below)When I watch my neignbor in R3 it says :192.168.7.7 1 INIT/DROTHER 00:00:37 10.0.2... view more
How to SDA Host Onboarding with ISE
Created by ldanny on 01-19-2020 04:48 AM
0
10
0
10
Introduction Host Onboarding is the term used when connecting an endpoint (hosts , IOT , Other devices) to the fabric , and can be accomplished in a couple of ways.One option is the "static" approach as oppose to the dynamic and secure approach using&nbs... view more
Cisco ASA failover status, Sensor for PRTG
Created by Oleg Volkov on 01-17-2020 10:10 AM
0
5
0
5
Hello!We update our ASA Failover sensor for PRTG.Improve usability.New manuals.You can read about it in attachment file.Download sensor from: http://www.powerc.ru/download/asafailover.zip
CreatePlease to create content
Discussion
Blog
Document
Video
Content for Community-Ad
FusionCharts will render here