Port triggering/forwarding on Cisco DDR2200-CL ADSL2 router?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-20-2011 09:16 PM - edited 03-03-2019 06:22 AM
First off, sorry if this is the wrong section...
I got a new router yesterday and I'm trying to re-portforward a server that I was hosting. I access my router page and add the ports to the port triggering page and it saves. After that, I go and check if my ports are open, but it is still saying that they are closed. The protocol is set at TCP. However, on my old 2WIRE router, I used to be able to set the application type as FTP. But theres no option to do it on this one.
Everything worked fine before on my old 2WIRE router. Also, if it makes a difference, I'm using the Windows 8 developer preview. I'm not sure if this would be the problem, but I also tried adding a port exception to the firewall but can't find the option to do so.
Thanks.
- Labels:
-
Other Networking

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-15-2011 11:05 AM
Try Small Business Forum. This one is for true Cisco products.
