Problem in NETkit & Golden Master

[mustafa.mail]

Hi

In installation of NetKit, I follow those stapes:

· Installing Solaris 7 and appalling latest patches.

· Customising this machine through the following the instruction from Documentation.

· Installing CSCOamale package.

· Installing NATkit.

In installation of NATkit, after finishing the step which is asking about Time zone, It’s giving the following message.

" Can't locating IP address, This is indicative too many simultaneous applications or configurations running.”

After this message it’s close the command window. And terminate the installation.

[ciscomoderator]

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.