cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
233
Views
0
Helpful
2
Replies
Highlighted
Beginner

Span Port

After I make span port on 2960G, that perticular port is in accessible to netowrk.As I am using Webssense to monitor traffice,and connected to span port

2 REPLIES 2
Highlighted
Contributor

i had a similar problem & it resolved with this:

monitor session # destination interface # ingress untagged vlan "native vlan#"

The additional statement on the destination part of session has resolved the issue.

Highlighted

HI Suresh, [Do Rate all HELPFUL Posts]

For SPAN Configuration, the Source and destionation port should be on the same switch.

SPAN sessions allows you to monitor traffic on one or more interfaces.

You can configure upto six SPAN Sessions.

Eg:

Switch(config)# monitor session 1 source interface fastethernet 4/10

Switch(config)# monitor session 1 filter vlan 57

Switch(config)# monitor session 1 destination interface fastethernet 4/15

To disable:

Switch(config)# no monitor session 1

Verify the SPAN Config:

Switch# show monitor session 1

Do RATE all HELPFUL POSTS.

Best Regards,

Guru Prasad R