03-29-2020 12:16 PM
Dear all
i have make router as PPPOE server ,
and more of 4000 Client is connected find
but sometime the clinet is stuck and can't connected
i open the wifi-router of one of client (he have problem , his user not connect )
and go to log fine in router
i see this message
May 23 04:25:36 pppd[933]: Timeout waiting for PADO packets May 23 04:25:36 pppd[933]: Unable to complete PPPoE Discovery May 23 04:25:52 pppd[933]: Timeout waiting for PADO packets May 23 04:25:52 pppd[933]: Unable to complete PPPoE Discovery May 23 04:26:04 wireless: ath0 New Access Point/Cell address:B4:FB:E4:DE:59:07 May 23 04:26:08 pppd[933]: Timeout waiting for PADO packets May 23 04:26:08 pppd[933]: Unable to complete PPPoE Discovery
many user have same issues , so they turnoff then turn-on they wifi-router , then they user is conneced
note : i make all my client in same VLan (from router to another switch's )
why some client can't PPPoE Discovery or he dealy ? and how to fix this from router side
some of my config in router
aaa authentication ppp default group radius aaa authorization network default group radius aaa accounting delay-start all aaa accounting nested aaa accounting update periodic 1 aaa accounting network default start-stop group radius aaa accounting system default start-stop group radius aaa server radius dynamic-author client 94.231.199.99 server-key 7 121F0C1517190E05242F342D212031015E44 server-key 7 104D000A0618 auth-type any ignore session-key ignore server-key aaa session-id common ! interface Virtual-Template1 mtu 1460 ip unnumbered Loopback0 no ip redirects ip nat inside ip tcp adjust-mss 1400 ip policy route-map ROUTE-TV no logging event link-status peer default ip address pool interface localpool keepalive 30 ppp authentication chap eap ms-chap ms-chap-v2 pap ppp ipcp dns 8.8.8.8 8.8.4.4 end
03-30-2020 06:23 AM
Hi,
The below messages indicate that the PPPoE client has sent the initial Discovery message, but failed to receive an offer:
May 23 04:25:36 pppd[933]: Timeout waiting for PADO packets May 23 04:25:36 pppd[933]: Unable to complete PPPoE Discovery
So either there is a bug, probably on the PPPoE client side, or there is something happening at layer 2 (like for example are the links towards your routers configured as portfast), or is there anything else in your environment which could affect the layer 2end-to-end connectivity?
Regards,
Cristian Matei.
03-30-2020 11:54 AM
03-31-2020 01:23 AM
Hi,
It has to work, if this happens from time to time, take a closer look at your VPLS environment, at the transport network.
Regards,
Cristian Matei.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: