USR Courier V.Everything init string for Console access

[nhellums]

I need help with an init string and dip switch setting for a USR Courier V.Everything M/N: USR3453B modem.

I want to be able to dial into my PIX firewall and have access to the console.

Thanks in advance for your help.

My E-mail address is nick.hellums@nelsonstud.com

[scottosan]

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a00800941c9.shtml

[colleencamacho59]

To install your internal Courier V.Everything, do the following:

Step One: Configure your internal Courier with jumpers

Step Two: Configure your internal Courier with DIP switches

Step Three: Insert your internal Courier

Step Four: Connect the cables

If you are using an IBM-PC compatible operating system, you may need

to change the jumper settings to a COM port or IRQ setting that is not

already used by your system.

For information about setting jumpers for different COM ports and IRQ

settings, see Chapter 7, Configuring Your Courier With DIP Switches and

Jumpers.

You may need to change your DIP switch settings. See Chapter 7,

Configuring Your Courier with DIP Switches and Jumpers, for more

information.

Turn off the computer's power and unplug the computer's power

cord.

[Georg Pauwen]

Just out of curiosity: where are these modems still supported ? I used these more than 20 years ago, but I was under the assumption that everything has moved to digital in the meantime...