cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
361
Views
0
Helpful
1
Replies

errdisable detect loopback on trunks

d-mark
Level 1
Level 1

Hi,

on interfaces configured as trunk, like

interface GigabitEthernet 1/0/1

switchport trunk encapsulation dot1q

switchport trunk native vlan 11

switchport mode trunk

!

and 'errdisable' detect and recovery configured for all causes with a timeout of 300 seconds a looped link is not detected. This is not the behavior I expected. Am I missing something?

I'm using Cat 3750 with 12.2(25).SED1.

If someone could help me, this would be fine.

thanks in advance and kind regards

Mark

1 Reply 1

b.hsu
Level 5
Level 5

check out the following command reference for enabling errdisable :

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_command_reference_chapter09186a008017f9b3.html#2233305

hope this helps.