cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
547
Views
5
Helpful
3
Replies
rafail.sharifov
Beginner

Command not shown under interface config

Hi, Community

I am inserting command "ip nhrp shortcut" and "ip nhrp map multicast dynamic" under tunnel interface but when i exit global config and show run interface tunnel, the configs i newly inserted is not shown

2 ACCEPTED SOLUTIONS

Accepted Solutions
balaji.bandi
VIP Expert

show run all ( do you see the config ?)

 

what is the device model ?

what version of code ?

 



BB


*** Rate All Helpful Responses ***

View solution in original post

Rob Ingram
VIP Mentor

@rafail.sharifov 

Those commands are default on newer IOS-XE code (no need to configure them), you'd need to view the full configuration using show run all in order to confirm those commands are configured correctly.

View solution in original post

3 REPLIES 3
balaji.bandi
VIP Expert

show run all ( do you see the config ?)

 

what is the device model ?

what version of code ?

 



BB


*** Rate All Helpful Responses ***

View solution in original post

Rob Ingram
VIP Mentor

@rafail.sharifov 

Those commands are default on newer IOS-XE code (no need to configure them), you'd need to view the full configuration using show run all in order to confirm those commands are configured correctly.

View solution in original post

rafail.sharifov
Beginner

@Rob Ingram , @balaji.bandi  Thank you guys. "Show run all" show that command on router.

Content for Community-Ad