02-01-2021 03:30 AM
Hi, Community
I am inserting command "ip nhrp shortcut" and "ip nhrp map multicast dynamic" under tunnel interface but when i exit global config and show run interface tunnel, the configs i newly inserted is not shown
Solved! Go to Solution.
02-01-2021 03:39 AM
show run all ( do you see the config ?)
what is the device model ?
what version of code ?
02-01-2021 03:43 AM
Those commands are default on newer IOS-XE code (no need to configure them), you'd need to view the full configuration using show run all in order to confirm those commands are configured correctly.
02-01-2021 03:39 AM
show run all ( do you see the config ?)
what is the device model ?
what version of code ?
02-01-2021 03:43 AM
Those commands are default on newer IOS-XE code (no need to configure them), you'd need to view the full configuration using show run all in order to confirm those commands are configured correctly.
02-02-2021 10:42 PM
@Rob Ingram , @balaji.bandi Thank you guys. "Show run all" show that command on router.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: