09-04-2002 02:25 PM - edited 03-09-2019 12:11 AM
Hi
When I start concentrator 3005, concentrator get stuck on :
Boot-ROM Initializing... Boot configured 32Mb...
...
Loading image ..........
Verifying image checksum ...........
Active image loaded and verified...
Starting loaded image...
( Nothing more ....)
How do I set 3005 back to factory defaults, or how to fix it?
Thanks
ben
09-04-2002 09:02 PM
Get a console connection to the concentrator, and get a session up to the concentrator.
Cold boot the concentrator and then as it is booting up, hit ctrl g on your
keyboard and a recovery menu would be presented to allow you to boot to the
previous image without any config.
09-05-2002 07:39 AM
Thanks.
after control-g, select option 6, or 2, still cannot boot, what need to do?
Ben
09-05-2002 04:33 PM
After doing a ctrl-g select option 5, toggle image so it would use the last known
good image. If it still doesn't boot, do a ctrl g again and select 6, to ignore config. See how you go, and if nothing works, log a case with TAC for further
troubleshooting.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide