distribution status

[c.alejandra]

After pushing a configuration to the sensor, and verifying the distribution status for the sensor through the Command tab of the CSPM client, the commands/messages displayed were like those displayed of a connection status request effectuated against the Policy Server in the left pane of the Event Viewer:

... xxx.yyy.zzz 45000 1 [Established] sto:000 with version 1

Does anyone know why this happened??

[beakley]

I am confused...

Where did you see this message? In the CSPM event viewer pane?

Thanks,

-JB

[c.alejandra]

No, through the Command tab of the CSPM client. The information displayed was similar to a connection status request when you place your mouce within the left pane of the event viewer, on one of the sensors, and then you right-click -and select connection status. In otherwords, what whas displayed was

... xxx.yyy.zzz 45000 1 [Established] sto:000 with version 1

instead of the usual information echoed about the distribution status of the pushed configuration. This is very odd.