Hi, I am currently using a 3015 (ver3.5.5), ACS (3.1) & the VPN client (3.5.1). Is it possible to implement password expiry when NOT using the windows domain controller for authentication (i.e. Using the CiscoSecure ACS internal database)?If so, does...
pix520£¬I have more than 2000 common network address£¬example 171.41.152.1 255.255.248.0.but I want do nat with 254 addresses only £¬example:171.41.159.0/24,Have 172.41.152.1-171.41.158.254 the address how come and show at pix520? is it?nat (inside) ...
Hi AllI would like to know whether or not the Cisco IDS can prevent SQL Slammer attack ?By the way where can look up all Cisco IDS can detect "worm" ?Thanks in advance
I'm trying to correctly configure ACL's to block a few TCP, and UDP ports. I not sure if I quite understand if I create a permit ACL will that emplicitly deny everything else? Say I want to block Telnet traffic I'll create an ACl that reads,<>access-...
--begin ciscomoderator note-- The following post has been edited to remove potentially confidential information. Please refrain from posting confidential information on the site to reduce security risks to your network. -- end ciscomoderator note -- ...
I'd like to start preparing for the new IDS exam 9E0-100. I;m looking for any suggestions on how to prepare. I've check CISCO press, but they only have the older book published in 2001 -- any suggestions?
I'm configuring a number of devices with site-to-site VPNs, using Microsoft Windows 2000 Certificate Services to provide the certificates. I have got the connections up and running successfully; however, when downloading the CRL I find that it does n...
Folks, I am trying to connect to a VPN 3005 concentrator and keep getting this message on the concentrator when i try to connect. Does anyone know a fix to this problem.Thanks
I want to do password recovery for the IDS 4210. I had read the process in which it requires a bootable disk and a CD . Disk software i can download from the web but i am confused about CD , which solaris operating system CD we should use ? and i am ...
I am having some trouble with vpn split-tunneling. One users seems to be able to access split-tunnel while all other users cannot even though they can authenticate. It was suggested to me that this may be because I am only using PAT. I have a limi...
I would like to assign an ip address to the FWSM and be able to access it externally. I have created a vlan-group and associated the module with the vlan that has been created on the switch. When trying to associate the FWSM interface to the Vlan t...
After pushing a configuration to the sensor, and verifying the distribution status for the sensor through the Command tab of the CSPM client, the commands/messages displayed were like those displayed of a connection status request effectuated again...
