Showing results for 
Search instead for 
Did you mean: 


Level 1
Level 1

I am exploring the idea of DMVPN. Currently I have about 15 sites on Cisco 2811 ISR routers connected to an ASA at the HQ on an IPSEC vpn. This number is expect grow to over 30. I'd like to incorporate a fully meshed vpn terminated back to a Cisco 3825 that is behind the ASA for branch to HQ traffic. Any docs or suggestions concerning this would be appreciated.

3 Replies 3

Level 1
Level 1

My experience with DMVPN has been smooth - I migrated connections from VPN 3K Concentrator to a 3825. Setup a single hub with multiple spokes. EIGRP neighbor connections up and running… I used DMVPN as a backup link - so each spoke has two links back to the main office. Once you have the hub setup and a single spoke - easy to roll out other sites. The guides offer step by step and great examples.

Take a look at this link - new PDF

Thanks for your reply. Are there any important considerations that need to be considered on the Ciscs ASA since the traffic will flow through that before terminating on the 3825?

You need to do some additional research - firewall config should have a rule to the 3825 allowing udp eq 500, esp, ahp, etc...

check out