Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
330
Views
0
Helpful
1
Replies

Failover

sightlay8
Level 1
Level 1

‎09-23-2008 05:59 AM - edited ‎03-09-2019 09:32 PM

I have two PIX 525 running version 8.03 with failover. One of the PIX license is Active/Active, and the other is Active/Standby (FO) license.

One hour ago, the PIX just failover. Currently the secondary PIX (Active/standby) is active, what will happen if this PIX had a problem, will it failover over back to the Primary (Active/Active) itself? or I should manually failover it back to the Primary now instead of waiting?

Thanks

Labels:
0 Helpful
1 Reply 1

suschoud
Cisco Employee
Cisco Employee

‎09-23-2008 09:36 AM

what will happen if this PIX had a problem, will it failover over back to the Primary (Active/Active) itself?

YES

or I should manually failover it back to the Primary now instead of waiting?

NOT NECESSARY.BUT IF YOU ARE LIKE MANY PPL OUT THERE WHO LIKE TO SEE PRIMARY AS ACTIVE ALWAYS...YOU CAN ISSUE " FAILOVER ACTIVE " COMMAND ON THE PRIMARY/STANDBY UNIT.This would make it active.

Regards,

Sushil

0 Helpful
Customers Also Viewed These Support Documents