07-28-2020 01:42 AM
Hi Team,
I cannot config or update policy with FMC (FTD FPR4100). When i update policy and want to save and deploy,
this error show
" deployment failed due to connectivity issues with the device or device is not responding. if problem persists after retrying later, contact cisco tac "
Kindly advise what i need to do.
Thanks.
07-28-2020 02:50 AM
08-25-2020 09:18 PM
Hi Rob Ingram,
Thanks for reply..
FTD System version: 4.0(1.140)
FMC Operating System Version 6.2.2
You meant doing ssh FTD use the command "capture-traffic" ? I don't see this command at CLI FTD. last time I reset FTD and connect back to FMC, and its Okay for three day. and same issue happen again. Before this happen, I configure interface channel. But when I tried to enable port and deploy, its Failed.
Kindly assist .
Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide