CAT 6513 IOS ver.12.2(18)SXF4
FWSM ver. 3.1(1)
Firewall module in slot 5 of 6513.
Firewall is setup for multiple context mode.
I have the following config on the switch:
firewall multiple-vlan-interfaces
firewall module 5 vlan-group 1
firewall vlan-group 1 2
interface vlan 2
ip adress 10.1.1.1 255.255.255.0
no shut
I can create a new context on the firewall and allocate an interface to that context.
The FWSM shows this interface as up/up:
Interface Vlan2 "", is up, line protocol is up
Hardware is EtherSVI
Available for allocation to a context
MAC address 0015.63bc.eb00, MTU not set
IP address unassigned
However, when I try to assign an IP address or set the Security level for the interface it fails, basically the commands:
"nameif"
"ip address"
are not available.
At this point, I am only looking to get an IP address assigned so that I can copy the latest ASDM file and manage via the GUI.
Any thoughts?