05-23-2006 12:05 AM - edited 03-09-2019 03:00 PM
Dear Sir,
Two FWSMs are deployed on separate Catalyst 6513 switches. The FWSMs are configured for inter-chassis failover. I also configured stateful failover. The FWSMs are running software version 2.3(3) and the Cat6513 are running Native Cisco IOS software.
The FWSM has 6 routed contexts and is monitoring 24 interfaces for failover. The following is output of "show failover" on the Standby FWSM. The "rerr" counters for "TCP NPs" and "UDP NPs" keep increasing rapidly. Is this normal or is it indicating some potential problems? I have two more pairs of FWSM elsewhere on the network, but they don't exhibit the same problem.
Please help.
FWSM# sh failover
Failover On
Failover unit Secondary
Failover LAN Interface faillink Vlan 901
Unit Poll frequency 1 seconds, holdtime 5 seconds
Interface Poll frequency 15 seconds
Interface Policy 1
Monitored Interfaces 24 of 250 maximum
failover replication http
Config sync: active
Last Failover at: 20:05:11 May 16 2006
This host: Secondary - Standby
Active time: 0 (sec)
--- Output omitted ---
Other host: Primary - Active
Active time: 589999 (sec)
--- Output omitted ---
Stateful Failover Logical Update Statistics
Link : statelink Vlan 902
Stateful Obj xmit xerr rcv rerr
General 78548 0 354399 0
sys cmd 78548 0 78548 0
up time 0 0 0 0
RPC services 0 0 0 0
xlate 0 0 0 0
TCP conn 0 0 4816 0
UDP conn 0 0 0 0
ARP tbl 0 0 275851 0
RIP Tbl 0 0 0 0
L2BRIDGE Tbl 0 0 0 0
Xlate_Timeout 0 0 0 0
TCP NPs 0 0 9934170 1360770
UDP NPs 0 0 117070 1360770
Logical Update Queue Information
Cur Max Total
Recv Q: 0 62 354403
Xmit Q: 0 1 78548
FWSM#
Thank you.
B.Rgds,
Lim TS
05-23-2006 12:20 AM
08-03-2006 09:01 AM
CSCsd58614
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide