Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Sir,I have the following port channel config on a Cisco 7609:!interface Port-channel1 ip address 10.10.10.10 255.255.255.0 no ip redirects no ip unreachables no ip proxy-arp ip ospf message-digest-key 1 md5 cisco123 logging event link-status no mp...
Hi Sir,Can anyone advise whether the SCE 2020 running SCOS version 3.5.0 support sending messages to syslog server?I want to configure the equivalent of the following Cisco IOS commands on the SCE platform:!logging host 1.2.3.4logging trap informatio...
Hi sir,I'm trying to locate the SNMP MIBs for Cisco 10000-PRE4 with IOS 12.2(33)SB5 and UPTO 8K SUBSCRIBERS W/3DES feature set.It's not available. Only the MIBs for 10000-PRE3 with same IOS version & feature set is available.Can I use the 10000-PRE3 ...
Hi Sir,I'm testing LACP etherchannel with ISG feature on a Cisco 10008 router.According to the following URL,http://www.cisco.com/en/US/docs/ios/12_2sb/feature/guide/gigeth.html#wp1111405ISG IP sessions feature is not supported on GEC bundles on a PR...
Hi Sir,I have a Cisco 7206VXR with NPE400. Its "sh version" is as follows:~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~Cisco Internetwork Operating System Software IOS (tm) 7200 Software (C7200-K4P-M), Versio...
Hi Joe,Here you go...Cisco IOS Software, 10000 Software (C10K4-K91P11-M), Version 12.2(33)SB5, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-2009 by Cisco Systems, Inc.Compiled Sat 04-Apr-09 11:03 by prod...
Hi,The outputs of "sh version", "sh bootvar", and "dir all" that I posted were before I copied the new IOS and bootloader images to disk0: and modified the boot commands.Sorry for the confusion. There's no mistake here.Thank you.B.Rgds,Lim TS
Hi,I tried to remove any "boot bootldr" command from the config and only left with "boot system flash disk0:c7200-k4p-mz.120-31.S6.bin".Still, it goes into ROMmon each time it is reloaded or power cycled.I also tried to delete all unused images on di...
