Getting sensor information

[mjuckett]

I am trying to look at how much RAM the sensor is using and how much of the hard drive. With CSPM you could still have IEV running on the sensor and log in and check these values. How do you get this information when you are running VMS? Are there commands I can run on the sensor to get this?

Thanks in advance.

[ywadhavk]

You should be able to still use the IDM to get that info from the sensors.

For 4.0 sensors, Device-->Support---> System information.

For 3.x sensors, Administration ---> System information

Thanks,

yatin

[zihussai]

Hi Megan,

On IDS 4.0, If you want to see how much memory and disk space is used on the sensor you need to use "show version" command.

Thanks

Zia