How to activate ADSM 5.0F on FWSM SW 3.1.1

[v.kreisel]

Hi,

I have installed SW 3.1.1 on my FWSM.

The documentation says that ADSM 5.0F is included in 3.1.1.

(http://www.cisco.com/en/US/partner/products/hw/modules/ps2706/products_data_sheet0900aecd803ded77.html).

Because I couldn't find/activate ADSM 5.0F I copied ADSM 5.1(1) on the FWSM which seams to work well.

Any idea about getting ADSM 5.0F installed/running ?

Thanks

Volker

[varakantam]

ASDM 5.0F is not available yet and maybe available in the next few weeks. 5.1(1) is not a fully supported configuration I beleive.

[pringlem]

Hello. I am also running my FWSM's on 3.1 and I made the mistake of assuming that ASDM 5.0F was part of the image. I have multiple contexts which are managed by individuals with little or no command line experience.

When can I expect to see ASDM 5.0F available?

-MP

[szehnder]

Hello. Same question here!

What are your experiences with the new release? Any problems regarding the update/daily business?

regs, Sam

[w.haslam]

When I try to copy ASDM 5.1(1) to flash:asdm I get an error message "Detected legacy ASDM version" and wont save. I had the PDM on there before which I believe is causing the problem. How can I get rid of it if I am using the 3.1.1 fwsm image?