11-08-2004 04:32 PM - edited 03-09-2019 09:23 AM
Hi,
Could someone send me a link to good ISD sensor CLI configuration , with some explanation.
There is no good example I could read, most of them are IDS MC, not the CLI
I need network blocking section with some explanation.
regards
Ranjit
11-10-2004 01:37 AM
Hello Ranjit,
You can find the details about the IDS config (using CLI) in the document below. you can configure all basic things with the CLI. Once you can manage your IDS with the VMS, its better to configure advance features using VMS or IDM.
http://www.cisco.com/en/US/products/sw/secursw/ps5052/products_installation_and_configuration_guide_chapter09186a00803261bd.html
hope this helps.. rate all replies if found useful...
All the best ..
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community