IOS FW available in cat4000

vidals · ‎02-18-2003

Hello,

I need to run IOS FW on cat4000-sup3.

Do you know if it is possible and what last IOS version/release is?

Thanks.

Stephane

#sh vers

Cisco Internetwork Operating System Software

IOS (tm) Catalyst 4000 L3 Switch Software (cat4000-IS-M), Version 12.1(11b)EW, E

ARLY DEPLOYMENT RELEASE SOFTWARE (fc2)

TAC Support: http://www.cisco.com/tac

Compiled Tue 14-May-02 13:31 by hqluong

Image text-base: 0x00000000, data-base: 0x00B1C1F8

ROM: 12.1(11br)EW

espwarsw1 uptime is 7 weeks, 4 days, 11 hours, 28 minutes

System returned to ROM by reload

System restarted at 03:22:30 UTC Fri Dec 27 2002

System image file is "bootflash:cat4000-is-mz.121-11b.EW.bin"

cisco WS-C4006 (MPC8245) processor (revision 7) with 262144K bytes of memory.

Processor board ID FOX061600ZK

Last reset from Reload

48 FastEthernet/IEEE 802.3 interface(s)

50 Gigabit Ethernet/IEEE 802.3 interface(s)

467K bytes of non-volatile configuration memory.

Configuration register is 0x2102

#sh mod

Mod Ports Card Type Model Serial No.

----+-----+--------------------------------------+-----------------+-----------

1 2 1000BaseX (GBIC) Supervisor Module WS-X4014 JAB061408T3

2 48 10/100/1000BaseTX (RJ45) WS-X4448-GB-RJ45 JAB06060825

3 48 10/100BaseTX (RJ45) WS-X4148-RJ JAE04231BES

M MAC addresses Hw Fw Sw Status

--+--------------------------------+---+------------+----------------+---------

1 0009.7ca3.f200 to 0009.7ca3.f5ff 1.3 12.1(11br)EW 12.1(11b)EW, EAR Ok

2 0005.5fa4.1be0 to 0005.5fa4.1c0f 1.0 Ok

3 0002.4b81.1e80 to 0002.4b81.1eaf 2.3 Ok

mostiguy · ‎02-19-2003

http://www.cisco.com/cgi-bin/Software/Iosplanner/Planner-tool/iosplanner.cgi?get_crypto=&data_from=&hardware_name=CAT4000-SUP3&software_name=&release_name=&majorRel=12.1&state=:HW&type=

The IOS upgrade planner is a great tool for this - tell it what device, and it gives you options. It also will tell you what ram and flash are required, which can be an issue for access routers.