no interfaces 2b seen in pdm2.0(2)

[chrrbc]

I upgraded a test PIX 520 from V6.1(3) to V6.2(1) and from pdm V1.1(1) to V2.0(2).

Only the inside interface is enabled on this test PIX FW.

My question is: Why in PDM V2.0(2) nothing is shown under system properties - category interfaces ?

All the rest looks fine. Also in the config (f.e. show conf) the interfaces are there. Is this a bug? Any similar findings in your environments?

[chrrbc]

Finally I found the solution myself. For your information I explain it here:

PDM V2.0(2) and probably also PDM V2.0(1) as well, will not show any interface when there is no interface WITH SECURITY0 defined in the PIX-config file.

Maybe you can use this information sometime.