01-22-2004 06:27 AM - edited 03-09-2019 06:11 AM
Hello All,
Have a problem I am looking for help on.
I have a pix506e V6.1(4) software and two spanking new pix 525's ( v6.3(1) ).
I can use my pdm succesfully to the 506e with use of the following 3 basic commands:
pdm location x.x.x.x 255.255.255.255 inside
http server enable
http x.x.x.x 255.255.255.255 inside
It prompts me for username and password after https'ing to the device and just simply lets me enter enable password with a blank username and pdm comes up.
On the pix525's I enter the same string of commands above , the browser/pix prompts for username and password , again I leave the username blank and enter the enable password. The browser then responds with page cannot be found.
Gives me the impression its password based - is there something new on the version ? Is it password/username related ? Am i going mad !
Any help would be appreciated
Regards
01-22-2004 08:48 AM
what does a "sh ver" say for pix and pdm versions?
My 501 pix came from the factory with a pdm version that was incompatible with the pix os version it came with. I got a distinct "wrong version" pdm error message though.
Anything in the logs? There is a debug pdm history command, but I haven't used it
01-22-2004 10:34 AM
Try using pix for the username or enable_15
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide